Top 10 common forklift crashes ， forklift operation should focus on these matters ！.

Top 10 common forklift crashes ， forklift operation should focus on these matters ！.

Blog Article

Do not ignore the forklift at the workplace. If the operation is bad, there will be severe accidents in minutes, and there are many mishaps including forklifts.

Case 1: The forklift cargo obstructed the chauffeur's sight, and the person in front could not be located, causing a moving crash.
Case 2: In order to maintain the equilibrium of the forklift when raising hefty goods, the staff members utilized their body weight as the counterweight, which nearly triggered casualties.
Case 3: The size of the forklift cargo surpasses the allowed size of the course and holds on the roadside shelf, which virtually creates an mishap.
Instance 4: Forklift is speeding up and rolls over during a turn.
Case 5: The forklift motorist did not observe the pedestrian, and the pedestrian did not see the forklift.
Situation 6: The forklift raises the workers unlawfully, the forklift driver does not put on the safety belt, the forklift lifter drops and the motorist is crushed when the forklift rolls over.
Instance 7: The forklift vehicle driver did not use a safety belt and dropped from the lorry when it rolled over and was squashed.
Forklift procedure ought to take notice of these matters ：.

Beginning.
1. Prior to beginning, observe the surroundings, and after confirming that there are no barriers that hinder the safety and security of driving, honk the horn first and after that begin.
2. For vehicles with hydraulic ( atmospheric pressure) brakes, the brake hydraulic pressure (air pressure) gauge must be safe prior to starting.
3. When the forklift starts with a tons, the chauffeur must first validate that the tons is secure and reliable.
4. The begin should be sluggish and consistent.

Driving.
1. When driving, the elevation in between the bottom end of the fork and the ground ought to be maintained 300mm-400mm, and the mast ought to be slanted backward. .
2. Do not raise the fork expensive when driving. When entering and leaving the job website or while driving, take care that there will be no challenges overhead. When the lots is traveling, the fork has to not be elevated too high, which will influence the security of the forklift. .
3. After unloading, the fork ought to be lowered to the regular driving position prior to driving. .
4. When transforming, if there are pedestrians or vehicles nearby, the driving signal needs to be issued initially. High-speed doglegs are prohibited. High-speed sharp turns will certainly trigger the automobile to lose lateral security and topple. .
5. When the forklift is downhill, it is purely restricted to switch off the flame and slide, and it is restricted to brake unexpectedly while driving with lots unless there are special situations.
6. When the forklift is running, it needs to comply with the traffic rules in the manufacturing facility and should keep a particular safety and security range from the lorry in front. .
7. When the forklift is running, the load needs to be in the lowest placement that does not hinder the driving, and the gantry needs to be appropriately slanted back. The lots shall not be elevated except when stacking or loading. .
8. The height of the lots need to not block the chauffeur's view. In unique situations, when the product influences the forward vision, drive at a reduced speed when reversing.
9. It is restricted to activate the ramp, neither to drive across the ramp. .
10. The risk-free driving rate of the forklift in the factory location is 5 km/h, and it must drive securely at a low rate when getting in the manufacturing workshop area. .
11. When the forklift is raised, lifted or driven, it is forbidden for workers to depend on the fork to hold items and play a balancing role. .
12. If problems are discovered, they will be fixed and reported in a timely manner, and they will never ever operate with diseases or hide them.

loading and dumping.
1. When fork-loading things, the distance between both forks ought to be changed as needed to make the load of both forks balanced Stand-on Electric Pallet Stacker and not manipulated, and one side of the thing ought to protest the shelf. .
2. It is forbidden to collaborate with a solitary fork or use a fork top or Electric Forklift Truck for Warehouse draw. In special circumstances, safety and security warning signs have to be set up to advise bordering pedestrians. .
3. In the process of loading and discharging items, the forklift has to be braked with the brake. .
4. The rate of the car ought to be slow and steady. Take care not to roll the wheels on the dunnage, so as not to stretch the rolled items and harm individuals. .
5. When utilizing a fork to fork the goods, the fork should be as deep as feasible under the load, and it needs to be kept in mind that the fork pointer ought to not touch other goods or items. The load needs to be stabilized with marginal back tilt of the gantry to ensure that the tons does not glide in reverse. The pole can be slanted onward somewhat when the tons is decreased to permit very easy positioning of the tons and extraction of the forks. .
6. It is prohibited to fork goods at broadband and ram hard items with the fork head. .
7. When the forklift is working, it is forbidden for individuals to stand around the fork, so as to prevent the collapse of the goods and harm individuals. .
8. Straining is banned, and it is forbidden to use forks to raise workers to engage in high-altitude procedures to prevent high-altitude dropping crashes. .
9. It is not enabled to make use of the brake inertia to slide, place, round or roll objects. .
10. It is not allowed to utilize forks to select, turn pallet unload.

Leaving .
1. It is restricted to leave the forklift when the products on the fork are in the air. Before leaving the forklift, you have to discharge the goods or reduced the fork structure.
2. Draw the parking brake take care of to dead or dispirit the emergency brake button.
3. The engine is switched off and the power is removed. (Except for special conditions, such as the driver does not leave the vehicle's line of sight and does not go beyond 1 min).
4. Remove the trick. .

Forklift Operation Precautions.
1. Prior to and after the forklift operation, the appearance needs to be checked, and fuel, lubricating oil and air conditioning water should be added.
2. Inspect the safety and security performance of beginning, running and stopping.
3. Examine whether the lights and horn signals are total and reliable.
4. Throughout the operation of the forklift, check whether the pressure and temperature are normal.
5. After the forklift is running, the external leakage must likewise be checked and the seals must be replaced in time.

Forklift Safety Operation Specifications.
1. You need to examine prior to leaving the cars and truck;.
2. When you come across somebody in front of you during driving, you need to send a signal at a distance of 5 m;.
3. The driving speed in the factory does not surpass 5 km/h;.
4. When driving, the low point of the cargo should be 0.3 m ~ 0.4 m in the air;.
5. The transforming need to not be also sharp to stop the tendency of " complimentary turning";.
6. Adding and down the incline should be slow and consistent, and no switching on the slope is enabled.
7. Do not drive throughout the slope. When the gradient is greater than 10%, the lorry needs to be driven in reverse when declining;.
8. When the forklift workers bring the goods and progress, if they experience large or hefty items and go to the chauffeur's line of vision, they must take the turning around workout
.
The "Eight Prohibitions" should be followed in the procedure.
1. Solitary fork operation is not allowed.
2. It is not allowed to lift the goods for cross country driving.
3. It is not allowed to get the goods by turning over the pallet with the fork.
4. It is not enabled to directly shovel chemicals, flammables and other harmful chemicals with forks.
5. It is not enabled to utilize inertia pressure to get the goods.
6. It is not enabled to use stopping force to exile round or easy-to-roll things.
7. It is not permitted to bring individuals to work with the pallet or fork, and it is strictly forbidden to stand under the fork after the fork is increased.
8. Do not drive laterally on inclines
.
Auto parking is not allowed under the following problems.
1. Curves, narrow roadways, railway crossings;.
2. Areas with a longitudinal incline greater than 5%.
3. When there is an obstacle on one side of the road, the opposite side of the section with the exact same length as the obstacle must be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844